If you have created track groupings in which you have defined relationships between various parameters, you can ensure that those relationships are maintained (or not, as you wish) when automation envelopes are being written. This is done using the group Automation Mode column on the Track Grouping Matrix.
如果您创建了轨道编组,并在其中定义了各种参数之间的关系,则可以确保在写入自动化包络时保持(或不保持)这些关系。这是使用轨道编组矩阵上的编组自动化模式列完成的。
As when the track parameters themselves are grouped, the automation mode status for each track in the group can be set to lead, follow, or both lead and follow. Here are examples. In each case, the grouping is similar to that used in the exercise file All Through The Night GROUPS.RPP. If you completed those examples it might help you to open that file now.
当轨道参数本身被编组时,编组中每个轨道的自动化模式状态,可以被设置为“主导”、“跟随”或“主导和跟随”。下面是一些例子。在每种情况下,编组都与练习文件All Through The Night GROUPS.RPP中使用的编组相似。如果您完成了这些示例,现在打开该文件可能会有所帮助。
Example
示例
In this example, both guitar tracks are set to act as both lead and follow in automation mode. The flag pan reverse is enabled. Both pan envelopes are armed (indicated by the colored circular button on the pan controls).
在本例中,两条吉他轨道的自动化模式都设置为同时充当主导和跟随。启用“标志: 声像反向”。两个声像包络都是预备的(由声像控件上的彩色圆形按钮指示)。
You can set either track to write (as in this example), touch or latch mode and the other will change with it. Any automation movements will then be written to both tracks (see right).
您可以将其中一条轨道设置为“写入”(如本例所示)、“触碰”或“锁存”模式,另一条轨道将随之改变。然后,任何自动化的操作都将写入两条轨道。(见右侧)。
Had the envelope been armed on only one of the tracks then the automation would have been written to that track only and not to the other.
如果自动化包络只在一条轨道上预备,那么自动化将只写入该轨道,而不会写入另一条轨道。 作者: 琴韵晓波 时间: 2021-7-4 13:14 点此转到本章目录点此转到总目录——【本文译者：王晓波，出处：视障者音乐制作交流基地】点此转到REAPER+SWS+OSARA中文语言包下载页面