17.7 将FX输出发送到另一轨道——REAPER用户手册中文版

琴韵晓波

楼主 琴韵晓波说：
17.7 Sending FX Output to Another Track
17.7 将FX输出发送到另一轨道

You are able to send of any track FX output directly to any other track, instead of or as well as to itself.
您可以将任何轨道的FX输出直接发送到其他任何轨道,而不是发送到其本身。
Consider an example such as this. You have a track, say a mandolin, with an FX chain that includes eq, EQ and compression. You want to create a send to, say, a reverb bus track, after the EQ and compression. In this case, simply place the EQ first in the chain, and leave its output at the default, channels 1/2 Here is another example.
考虑这样一个例子。你有一条轨道,比如曼陀林,有一个FX链,包括eq、EQ和压缩。你想创建一个发送到,比如说,混响总线轨道,在EQ和压缩之后。在这种情况下,只需将EQ放在链中的第一个位置,并将其输出保留在默认的通道1/2。这里是另一个示例。
Left is shown an FX chain for (say) Track 1 of a project. Reverb is applied after the EQ. You could send the reverb output directly to another track instead of track 1, to further work on it there.
左边显示了一个工程的轨道1的FX链。混响是在EQ之后应用的。你可以将混响输出直接发送到另一条轨道,而不是轨道1,以便在那里进一步处理。
To do this, click on the 2 in/out button on the FX interface.
要执行此操作,请单击FX界面上的2 in/out按钮。
Select the EQ and direct its output both to channels 1/2 and to any other available pair (e.g. 7/8), as shown (right).
选择EQ并将其输出指向通道1/2和任何其他可用对(如7/8),如图(右)所示。
Now select the Reverb plug-in and use its pin connector to direct its channel input from and output to only  channels 7/8.
现在选择Reverb插件,并使用其针脚连接器将其通道输入和输出仅指向7/8通道(在本例中)。
We can then create a new track - for example, Track 2 immediately after the current track) and create a send from channel 5/6 on the source track to channels 1/2 on the new track. Solo track 2 to hear the reverb by itself.
然后,我们可以创建一条新轨道(例如,当前轨道之后的轨道2),并创建从源轨道上的5/6通道到新轨道上的1/2通道的发送。独奏轨道2,可单独听到混响。

琴韵晓波

沙发 琴韵晓波说：
点此转到本章目录    点此转到总目录——【本文译者：王晓波，出处：视障者音乐制作交流基地】    点此转到REAPER+SWS+OSARA中文语言包下载页面