7.26 单独使用吸附设置和网格设置进行吸附——REAPER用户手册中文版

琴韵晓波

楼主 琴韵晓波说：
7.26 Snapping with Separate Snap and Grid Settings
7.26 单独使用吸附设置和网格设置进行吸附

The above examples use the same set of snap parameters for grid display as is used for snapping. In other words, the snapping would take place to the nearest grid position. Let's now see what we can do if we disable the option Grid snap settings follow grid visibility.
上面的示例为网格显示使用了与吸附相同的吸附参数设置。换句话说,吸附将发生在最近的网格位置。现在让我们看看,如果我们禁用“网格吸附设置跟随网格可见性”,我们可以做些什么。
We have also changed the minimum pixels setting for grid line spacing, in this case to 20 pixels, whilst still specifying (at the point where the cursor is shown on the screen shot) a grid snap spacing of one sixteenth beats. This produces a less cluttered display on the screen.
我们还更改了网格线间距的最小像素设置,在本例中为20像素,同时仍指定(在屏幕截图中显示光标点处)网格线间距为1/16拍。这样可以减少屏幕上的杂乱显示。
Provided you have zoomed into your project sufficiently, gridlines will be shown for every quarter beat but snapping will take place between as well as on the gridlines, at every sixteenth beat.
如果您已充分放大工程,则每1/4拍都会显示网格线,但吸附将在每1/16拍的网格线之间以及网格线上进行。
The Media items snap to option can be set to Snap both start/end, Only snap at start/snap offset or Mouse position dependent (i.e. at the mouse position nearer at the time, the start or the end).
“媒体对象吸附”选项,可以设置为“开始/结束处都吸附”、“仅在开始/吸附偏移处吸附”或“根据鼠标位置(即,在时间,开始与结束时较接近的鼠标位置)吸附”。
Tip: When snapping is enabled, this can be over ridden when selecting a loop along the timeline by holding down the Ctrl key while you make the selection.
提示: 启用吸附时,在构建选择时按住Ctrl键,可以覆盖沿时间轴选择循环时的设置。
Note: The action list includes an action Item: Set snap offset for item under mouse to mouse position.
注意: 操作列表包括一个操作“对象: 设置鼠标下对象到鼠标位置的吸附偏移”。

琴韵晓波

沙发 琴韵晓波说：
点此转到本章目录    点此转到总目录——【本文译者：王晓波，出处：视障者音乐制作交流基地】    点此转到REAPER+SWS+OSARA中文语言包下载页面